Показать сообщение отдельно
Старый 11.04.2019, 22:40 (01:40)   #106
ghans
Экстремал
 
Аватар для ghans
 
Город: Москва
Touareg NF 3.6 V6FSI
Регистрация: 14.09.2012
Сообщений: 1,693
Поблагодарил(а): 1,074
Благодарностей: 1,312
Репутация: 1787

ghans Первый курсghans Первый курсghans Первый курсghans Первый курсghans Первый курсghans Первый курсghans Первый курсghans Первый курсghans Первый курсghans Первый курсghans Первый курс
По умолчанию

Решил подружить туарег с воротами Levigato от Alutech


Для этого приобрёл официальный Homelink адаптер/приёмник https://www.shopssl.de/epages/es1056...oducts/PR433-4

Приёмник с воротами подружился с полпинка - с тестовой кнопки ворота открывает и закрывает. Проблема пришла откуда не ждали. Не могу подружить с туарегом
Вот, что пишет официальная инструкция
   Цитата:
Before you can use your HomeLink system, your receiver has to
learn the transmitter code. Park your vehicle about 3 metres away
from the receiver (not under the door, as it could be operated during
the programming process).
Перед использованием, надо обучить. Нет возражений.
   Цитата:
Then perform the following steps:
1. Press and hold all 3 transmitter buttons simultaneously for
30 seconds in your car. (The HomeLink indicator light glows
for 20 seconds, fl ashes for another 10 seconds and then
goes out.)
2. Release all 3 buttons when the HomeLink indicator light turns off.
Объясните мне, дурню, какой индикатор должен загореться, а потом помигать, а потом погаснуть? Их у нас два!!! И не горит ни один. Точнее, при длительном нажатии, загорается один, причём красным, потом тут же гаснет.... и ничего не происходит.
   Цитата:
3. Go to the receiver, open the lid, press the programming button (Learn A) for
Channel A, and release it. The indicator light for channel A then glows for 30
seconds.
Делаю, всё загорается
   Цитата:
4. Go back to your vehicle and press the selected transmitter button at least 2-3
times in a row within 30 seconds. Indicator light on receiver goes out.
Your receiver now knows the code of the relevant transmitter button. You can
test this by pressing the HomeLink button. If the door does not move, you
should make sure that the transmitter indicator light is switched off before you
repeat the above steps.
Ну и дальше - тишина. Есть какие нибудь идеи???? Я уже измучился....

Последний раз редактировалось ghans; 12.04.2019 в 11:56.
ghans вне форума   Ответить с цитированием Вверх