Регулировка производится со снятой накладкой вокруг нужной ПТФ (см картинку).
Замены лампы ПТФ производится через лючок в арке.
Как поменять блок ПТФ:
Removing and installing fog light
Removing:
– Switch off ignition and all electrical consumers and remove ignition key.
– Remove fog light trim → General body repairs, exterior; Rep. gr.63.
– Unscrew the securing bolt -1-, pull the front fog light -2- out of its side mountings -arrows- and take it out of the body aperture taking connected wiring length into consideration.
– Release and disconnect connector -1- and remove front fog light.
Installing:
Installation is carried out in the reverse order. When installing observe the following:
– Tighten securing bolt -1- to 2 Nm.
– Check headlight functions.
– Check fog light settings and adjust if necessary
|